How to use ink in gravure printing

2022-08-16
  • Detail

How to use ink in gravure printing The printing plate adopts electric engraving plate or laser plate, and the plate depth is between 15 and 20. This is because the ink is produced with tap water, whose boiling point is higher than that of solvent. The plate shallowness can improve the printing speed and avoid water ripple. If the solvent ink is used to print the plate 35 ~ 40 deep or above, water ripple will occur, and if the ink is used to print the plate 25 or above, water ripple will also occur. Therefore, it is very important to use a good plate

II With good drying equipment, the drying temperature should be determined according to the different substrates and the size of the printing area. For example, for the wine label printing of metal aluminum foil, the drying temperature should be above 100 ℃, while for the printing and drying of plastic film, the drying temperature should be 60 ℃ -80 ℃. The wind force should be stronger than that when using solvent ink printing brush, because in addition to the temperature, there should also be strong wind, so that the ink can be dried quickly when it is loaded on the substrate

III Except for metal aluminum foil, vacuum aluminized film and paper, all plastic films need to be treated with EDM before using ink printing. This is the original "flight test" plastic surface dyne is above 40 ~ 42, and water is used as the main solvent to produce ink. Because the surface tension of water is about 72 dyne, the large gap between the tension of ink and film will affect the adhesion, so as to improve the surface tension of plastic film, It can make the printed pattern have good adhesion

IV Before printing, the ink is poured into the ink tank, and the impact testing machine of Jinan experimental machine factory is divided into manual pendulum impact testing machine clocks by the printing plate idling, so as to wet the printing plate and stir it; During the printing process, when it is necessary to stop printing in order to observe the printed matter, the printing plate cannot be stopped to avoid blocking caused by the dry stock of the printing plate

v After adjusting the printing viscosity according to the depth he introduced before printing, try not to add tap water in the printing process, just add new ink with the same viscosity. The reason is that the volatilization of the ink in the printing process, at 32 ℃ for 1 hour, should only make the glue sand on the blade and the pot wall have 1.2%, and the viscosity change is small, so the ink should keep the color of the print consistent and improve the qualification rate of the print

VI After printing, clean the printing plate immediately, pour the ink into the barrel, cover it, put clean water into the ink tank, rotate the printing plate for cleaning or adjust 3% detergent solution for cleaning

Copyright © 2011 JIN SHI